6/26/2020 0 Comments How to fix a chainsaw?The chainsaw is the best tool to cut the wood, metals, and plastics as well. And you can easily use this chainsaw; you should wear gloves and protection cloth at the working time. You can also fix your chainsaw easily in the perfect place. For that you should check the chain brake is engaged are not. After that the chain tension may be too tight, you should adjust it for your flexibility. Easy to fix, just loosen the bar-retaining nuts and rotate the tensioning screw counterclockwise to the correct tension. Then tighten the nuts back up. How to check the guide bar and chain assembled correctly?Check the guide bar and chain assembled in perfect place or not. Check out the removing or replacing the Guide Bar and Chain’ section in your gas chainsaw manual. Install the chain and make sure the cutters are positioned in the proper direction to cut. If the chain’s installed backward, it makes cutting wood difficult. Please reference removing or replacing the Guide Bar and Chain section in the manual. Then check your air filter, a dirty air filter can affect your gas chainsaw’s ability to cut. Issues like low power, poor performance, or if the engine’s stalling during cutting could all be signs you need to clean it. After cleaning the air filter, let it dry. If you give enough time to dry the air filter it may cause to affect your machine. After letting it dry fix the chainsaw chain into the machine, and fix it with the right place of the tree, which part you want to cut from the tree. You can make a mark on the right place using the marker after that you can cut it easily. This will be an easy and simplest way to fix the chainsaw incorrect place to cut the tree.
0 Comments
You can use two ways to check if your chain is too tight, and both ways will start by you pulling the chain off the chain bar to check its tension. If you find it too hard to lift off the bar with adequate strength, then it’s a good sign that the chain is too tight and needs loosening. However, if you manage to lift the chain somewhat, but still the drive links are mostly beneath the bar, then it’s still slightly tight and it needs to be relaxed a bit to be in perfect condition. Is tight chain affecting the chainsaw?If your chainsaw is too tight, then it can be damaging to the machine itself and can affect the chain motor significantly. The tightness of the chain will put more strain on the motor due to the added friction, which in turn will cause it to wear down much more quickly than it normally would with regular usage with decent tension in the chain. The chainsaw model won’t have much effect on this as even the Remington RM1425, which is considered to be the best chainsaw for the money, would face similar results in such a scenario. Is a loose chain is much more dangerous as compared to a tight chain?A loose chain is much more dangerous as compared to a tight chain, because not only will it wear down the motor, but will also carry the hazard of coming off the metal bar and slinging across the room, which could be towards your direction as well. So make sure it is tightened up properly. However, if your chain does fall off, you may have the question of how to put a chain back on a chainsaw. Well, don’t worry because we’ve got you covered. Firstly, remove the two bar nuts and the tension bar below them as well so the bar is relaxed. Make sure the chain and the bar both are clean as well. Place the chain on to the bar with the drive links facing away from you, and rotate the bar till the chain is completely on the bar. Also, you can read more about the different types and stages of chainsaw. |