You can use two ways to check if your chain is too tight, and both ways will start by you pulling the chain off the chain bar to check its tension. If you find it too hard to lift off the bar with adequate strength, then it’s a good sign that the chain is too tight and needs loosening. However, if you manage to lift the chain somewhat, but still the drive links are mostly beneath the bar, then it’s still slightly tight and it needs to be relaxed a bit to be in perfect condition. Is tight chain affecting the chainsaw?If your chainsaw is too tight, then it can be damaging to the machine itself and can affect the chain motor significantly. The tightness of the chain will put more strain on the motor due to the added friction, which in turn will cause it to wear down much more quickly than it normally would with regular usage with decent tension in the chain. The chainsaw model won’t have much effect on this as even the Remington RM1425, which is considered to be the best chainsaw for the money, would face similar results in such a scenario. Is a loose chain is much more dangerous as compared to a tight chain?A loose chain is much more dangerous as compared to a tight chain, because not only will it wear down the motor, but will also carry the hazard of coming off the metal bar and slinging across the room, which could be towards your direction as well. So make sure it is tightened up properly. However, if your chain does fall off, you may have the question of how to put a chain back on a chainsaw. Well, don’t worry because we’ve got you covered. Firstly, remove the two bar nuts and the tension bar below them as well so the bar is relaxed. Make sure the chain and the bar both are clean as well. Place the chain on to the bar with the drive links facing away from you, and rotate the bar till the chain is completely on the bar. Also, you can read more about the different types and stages of chainsaw.
0 Comments
Leave a Reply. |